Investigation of the pressure generated in the mould cavity during polyurethane integral skin foam moulding
P. Grob, J. Marosfalvi
Vol. 2., No.7., Pages 511-519, 2008
DOI: 10.3144/expresspolymlett.2008.61
DOI: 10.3144/expresspolymlett.2008.61
Corresponding author: P. Grob 
GRAPHICAL ABSTRACT
ABSTRACT
An industrial scale measuring system was set up to investigate the pressure arising in the mould cavity during polyurethane integral skin foaming. The system is able to measure the pressure arising in the mould cavity and the pressure distribution using a piezoresistive pressure sensor. The pressure distribution was measured at 18 points along the mould surface at constant production parameters. Then six production parameters, which affect the pressure, were investigated in detail with the Taguchi method of experimental design. The results of the design were processed by ANOVA (analysis of variance). Three major influencing parameters were estimated by regression analysis. Finally an equation was developed to give a good estimation to the pressure arising in the mould cavity.
