The analysis of injection molding defects caused by gate vestiges
T. Tabi, A. Suplicz, F. Szabo, N. K. Kovacs, B. Zink, H. Hargitai, J. G. Kovacs
Vol. 9., No.4., Pages 394-400, 2015
DOI: 10.3144/expresspolymlett.2015.37
DOI: 10.3144/expresspolymlett.2015.37
Corresponding author: J. G. Kovacs 
GRAPHICAL ABSTRACT
ABSTRACT
Issues of product safety are the most serious problems of an injection molded product due to their risk to human health. Such a safety problem can be the needle-shaped vestige at the gate zone of injection molded products, called a gate vestige. Only observations of the formation of gate vestiges can be found in the literature, but the processing parameters influencing their dimensions, especially their height have not been studied yet. Our goal was to study the effect of various injection molding processing parameters and gate constructions on gate vestige formation.
